How to set up NorthStar Navigation Cube (One Cube)

This applies to Braava 320, Braava 380t

Follow these instructions to set up the NorthStar Cube, as you prepare for a cleaning cycle.

 

  1. Insert 2 C Batteries into the Cube and snap the Battery door shut.
  2. Turn on the Cube by pressing the button on its back corner. A blue light will flash on the opposite corner indicating that it's turned on.
  3. Place the cube on an elevated surface near the center of the area you want to clean. For best results place the Cube where it has a clear view of the ceiling (not under shelves, lit fluorescent lights or ceiling fans) and away from Plasma/LCD TVs. Do not move the Cube during a cleaning cycle or put it on the floor. If there is a choice of rooms, use the largest room to maximize floor coverage.
  4. Place the Braava about 1.5 meters in front of the Cube and press one of the cleaning modes (Sweep or Mop). The blinking light on the Cube should turn solid shortly after the cleaning cycle begins.

Image    Image            Image